
Reconnecting to the Host
Save changes whenever you reconfigure Imager settings.
6-4 COPYRIGHT © 2005 MICROSCAN SYSTEMS
Save
Settings
Clear
all Data
Default
to USB
Clear XML
Rules
Default
to PS2
Reconnecting to the Host
When reconnected to the host, or when the Bluetooth Radio is back in range, the
Imager will automatically detect the connection and, depending on the Batch Mode,
transfer or log (retain) buffered data.
The Imager is considered connected if:
• It is in RF Two-Way Mode and the Bluetooth radio is in range and active.
• It is in PS2 Keyboard Mode and a PS2 cable is connecting the Imager to a host via
the keyboard.
• It is in USB Keyboard Mode and a USB cable is connecting the Imager to a host.
•It is in
RS-232 Mode
and the cable is attached to a host with power supply plugged
in.
Transfer Options
Auto Transfer Options
In addition to the above options, you can program the MS-Q to transfer buffered
memory automatically or not whenever a connection to a host is established.
Typically this setting is set to Enable and the choice of sending or not sending is
made in Send & Log, Send & Buffer, and Log Only options.
Transfer All Data in
Memory
This will send all data
in memory every time
the symbol is read.
Transfer only Unsent Data
This symbol will send only the data
in memory that hasn’t already
been sent when the symbol is
scanned. Note: This ONLY works in
Send & Log Mode.
Delete Scanned Data
from Memory
Enable Auto Transfer
(Default)
Disable Auto Transfer
Scanning this symbol
will erase all data in the
Imager’s non-volatile
memory.
Komentáře k této Příručce