Microscan MS-4X Uživatelský manuál Strana 13

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 68
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 12
MS-Connect 210 User’s Manual 1-5
Setup and Operation
Connect the System
There are a number of different ways to connect a reader, the MS-Connect 210, and a host.
The 19-pin reader connector; the Micro-Change connectors for the power supply, optional
Ethernet, and optional object detector; and three CGBs are located at the back of the unit.
Connecting a 10-28 Volt Reader to the MS-Connect 210
If you are using an MS-9, MS-820, MS-860, MS-890, Quadrus EZ, or Quadrus Verifier:
1. Attach the 19-pin to 25-pin Reader Cable to the MS-Connect 210 via the 19-pin reader
connector, shown in the illustration above.
Important: The MS-9 requires a 19-pin to 15-pin Reader Cable, P/N 61-000127-01.
The MS-820 requires a 19-pin to 15-pin Reader Cable, P/N 61-000121-01.
2.
Tighten the cable housing at the 19-pin reader connector on the back of the MS-Connect
210 unit.
3. Attach cabling inside the wiring box.
4.
Attach an Object Detector (optional) to the MS-Connect 210 via the trigger Micro-Change
connector, shown in the illustration above.
5.
Attach the Power Supply to the MS-Connect 210 via the power Micro-Change connector,
shown in the illustration above.
19-pin Reader
Connector
Trigger Micro-Change
Connector
Power Micro-Change
Connector
Large CGB
accomodates
RJ45 Ethernet
connector
MS-Connect 210 Connectors
CGBs
8-pin M12 Industrial Ethernet Micro-Change Connector (optional)
CAUTION: Be sure that all cables are connected BEFORE applying power to
the system. Always power down BEFORE disconnecting any cables.
Zobrazit stránku 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Komentáře k této Příručce

Žádné komentáře