Microscan MS-4X Uživatelský manuál stáhnout pdf (Strana 20)

1-12 MS-Connect 210 User’s Manual

Connect the System

Powering Additional Readers from the Terminal Blocks

The MS-Connect 210 can power up to three additional readers during active operation.

This is accomplished by wiring the additional readers to terminal blocks J2 through J5

inside the box, as shown below.

Note: If you are using MS-890s or Quadrus EZs, the MS-Connect 210 can power up to

two additional readers, due to the greater power demands of those models.

Reader 2

Connect the positive wire of the reader’s Reader Cable to J2 PWR+ (Pin 1), the negative

wire to J2 PWR- (Pin 2), and the Chassis GND wire to J3 (Pin 3).

Reader 3

Connect the positive wire of the reader’s Reader Cable to J4 PWR+ (Pin 1), the negative

wire to J4 PWR- (Pin 2), and the Chassis GND wire to J3 (Pin 2).

Reader 4

Connect the positive wire of the reader’s Reader Cable to J5 PWR+ (Pin 1), the negative

wire to J5 PWR- (Pin 2), and the Chassis GND wire to J3 (Pin 1).

The primary reader, or Reader 1,

is powered through the 19-pin

reader connector at the back of

the unit.

Terminal Blocks J2 - J5

MS-Connect 210

Power Supply

Micro-Change

Connector

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Žádné komentáře

Microscan MS-4X Uživatelský manuál Strana 20