Microscan MS-4X Uživatelský manuál stáhnout pdf (Strana 33)

MS-Connect 210 User’s Manual 2-5

Using Ethernet

Configuring Network Parameters (cont.)

4. Look for the default IP address in the Network Destination column. If it does not

appear there, contact your IT department.

5. At the command prompt, type

telnet [MS-Connect 210 IP address] 9999

and type

Enter

6. At the Telnet prompt, type Enter.

7. To configure the IP address in the Telnet session, type 0 and Enter.

Note: “Netmask: Number of Bits for Host Port” will appear in the command prompt.

This defines the number of cleared bits (“0” bits) in the LSB (least significant bit) of the

32-bit Netmask, starting at the right.

Example: 255.255.255.0 = 8 “0” bits

255.255.0.0. = 16 “0” bits

255.0.0.0 = 24 “0” bits

8. Follow the command prompts to configure the IP address.

9. When done, type 9 and Enter to save settings.

10. At the command prompt, type ping [MS-Connect 210 IP address] and type Enter.

11. If the MS-Connect 210 responds to the pings, it is ready to communicate.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

Žádné komentáře

Microscan MS-4X Uživatelský manuál Strana 33