Microscan MS-4X Uživatelský manuál stáhnout pdf (Strana 15)

MS-Connect 210 User’s Manual 1-7

Setup and Operation

Connecting an MS-Q Imager to the MS-Connect 210

Once you have a reader connected to the MS-Connect 210 by RS-232, you can simultaneously

connect an MS-Q by wiring it directly to the MS-Q terminal block inside the box (

J15

1. Unscrew one of the three CGB caps at the back of the unit.

2. Clear the CGB’s access hole to create a cabling route

into the box.

3. Pass a pre-stripped MS-Q Reader Cable (61-000066-02

or user-supplied) through the access hole so that the

reader connector is outside the box and the end to be

wired is inside the box.

4. Wire the MS-Q Reader Cable to the MS-Q terminal block (J15).

To inside of wiring box

•Wire +5V to Pin 1 (VIN; red)

•Wire TX232 to Pin 2 (RS-232 Transmit; brown)

•Wire RX232 to Pin 3 (RS-232 Receive; orange)

•Wire HH GND to Pin 5 (Ground; black)

MS-Q Reader

Cable

(61-000066-02

or user-supplied)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

Žádné komentáře

Microscan MS-4X Uživatelský manuál Strana 15