Microscan QX Hawk Uživatelský manuál stáhnout pdf (Strana 229)

100

101

QX Hawk Industrial Imager User Manual 5-131

Parameters

Latch Mode 2 (Unlatch Opposite Condition)

The programmable output is activated when the Output On condition has been met and

held active until the opposite condition selected under Output On has been met.

For example, if No Read is enabled under Output On, the programmable output will go

active on a No Read and remain active until the opposite condition, a good read, occurs.

If the Output Condition is set to Read Cycle Data Valid, then the read cycle will continue

but every new Read Cycle Data Valid event causes the output to change state to the

opposite condition. This provides a toggle event per every read cycle output. The only

known outout state will be the on a power-on or reset. After reading begins, the state

becomes undetermined. Only the state change itself has meaning—not the absolute value.

Latch Mode 3 (Unlatch Re-enter Read Cycle)

The programmable output is activated when the Output On condition has been met and

held active until a new read cycle begins.

Note: All of the Output On modes are inhibited when any Diagnostic Warning is active

for Output 1.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 459 460

Komentáře k této Příručce

Žádné komentáře

Microscan QX Hawk Uživatelský manuál Strana 229

Komentáře k této Příručce

Související produkty a manuály pro Čtečky čárových kódů Microscan QX Hawk