
1-10 MS-4 Imager User’s Manual
Calibrate Settings
Step 8 — Calibrate Settings
MS-4 image settings can be adjusted automatically for optimum readability by either the
EZ button or by ESP.
During the calibration routine, the reader will flash its amber read rate percent LEDs and
red illumination LEDs while searching through various focus and camera settings and
determining the best configuration for decoding symbol data. Upon successful completion
of this routine, a green LED pattern will flash brightly and illuminate the symbol. If unsuccessful
,
the Imager will emit 5 short beeps and stop searching.
Calibrate by EZ Button
1. Hold down the EZ button about two seconds and release when you hear two short
beeps. The 20% and 40% LEDs will illuminate.
2. The Imager will search through various camera and IP settings to determine
the best
configuration for decoding symbol data
.
Important: The object must be centered in the field of view for the calibration process
to be successful.
Note: To end all EZ button functions, press the EZ button once and quickly release.
Calibrate by ESP
1. Click the Calibrate button.
2. The Imager will search through various camera and IP settings to determine
the best
configuration for decoding symbol data
.
A successful calibration will display a green frame around the symbol, and the following
message will appear: “Uploading all reader parameters.” After a moment the symbol’s
data and related features will be presented under the “Symbol Information” box below
the image display window.
Calibrate by Serial Command
Send <@CAL> to begin calibration.
Komentáře k této Příručce