Microscan MS-4 Uživatelský manuál Strana 23

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 390
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 22
MS-4 Imager User’s Manual 1-11
Quick Start
Step 9 — Test Read Rate
This test will let you know the percent of good reads per image captures the Imager is
producing.
Testing by EZ Button
1. To start the read rate test, hold down the EZ setup button about three seconds until you
hear three short beeps. The 20%, 40%, and 60% LEDs will illuminate.
While the symbol is being decoded, the read rate LEDs will indicate the correspond-
ing read rate percentage on the back of the unit.
2. To end the read rate test, press the EZ button and quickly release.
Testing by ESP
1. Click the Test button to start the read rate test and Stop to end it.
If your symbol has been successfully decoded, its data and related features will be
presented under “Symbol Information.” Also, while the symbol is being decoded, the read
rate LEDs will indicate the corresponding read rate percentage on the back of the unit.
2. To end the test, click the Stop button.
Testing by Serial Command
You can also start a test with the <C> or <Cp> command and end it with the <J> command.
Zobrazit stránku 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 389 390

Komentáře k této Příručce

Žádné komentáře